McFarlane -Seat Rail - 0511243-1-(Inboard LH or RH)

McFarlane seat rails do not have pre-drilled rivet holes in the rail base allowing the installer to exactly match the aircraft floor rivet pattern. McFarlane discovered while installing and developing our replacement seat rails that the seat rail attachment hole pattern was not consistent from aircraft to aircraft. Even small inconsistencies in the hole locations in the aircraft floor make installation of new seat rails very difficult. For this reason, McFarlane does not pre-drill rivet holes at the factory. (Existing stock may have a few pilot attachment holes drilled at the factory.) This allows the installer to precisely locate the attachment holes to match the holes in the aircraft floor. All special sized or machined attachment holes are machined to finish dimensions. It is necessary to replace all fasteners when the seat rails are installed.

Features

• Carefully engineered with many improvements
• Added strength and longer life
• Anodized for corrosion and wear resistance
• Easier installation
• Full interchangeability with the original Cessna parts

Supersedures

Aircraft Eligibility